372.023 Simulation of electrical machines and drives
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2019W, VU, 2.0h, 3.0EC

Properties

  • Semester hours: 2.0
  • Credits: 3.0
  • Type: VU Lecture and Exercise

Learning outcomes

After successful completion of the course, students are able to establish simulation models starting from machine equations and power electronics block diagrams. Students will further be able to test and verify these simulation models based on simulation results taken at rspecific operating points.

Subject of course

Documentation only offert in German

Teaching methods

Simulation is done either based on pre-fabricated drive models or by development of individual models. Simulation language is Matlab/Simulink.

Mode of examination

Immanent

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Wed13:00 - 14:0009.10.2019 Vorbesprechung - Zeichensaal (3.Stock, altes EI)

Examination modalities

The individual steps and milestones during the development of the model as well as verification is checked and discussed continuously and in addition has to be documented.

Course registration

Begin End Deregistration end
22.09.2019 00:00 30.11.2019 23:59 29.11.2019 00:00

Registration modalities

über TISS oder bei der Vorbesprechung Ort: persönlich

Curricula

Study CodeObligationSemesterPrecon.Info
710 FW Elective Courses - Electrical Engineering Elective

Literature

Lecture notes for this course are available. Sekretariat des Instituts E370-2

Miscellaneous

  • Attendance Required!

Language

German